How long will the installation take?

Posted · Add Comment

Generally this will depend on the size of the boat and the system you choose. The general system installation requires mounting a special ring to the hull for each transducer to be installed using the provided bonding resin, mounting of the control box(es) near the Transducer mounting rings and running some cables. In a setup with more than one system a simple link cable is run from one transducer control module to the next via the pre-existing wire runs throughout the boat. Generally it will take approx. 3 hours total time to install our system. It is a requirement however that the transducer mounting rings are allowed approximately 24 hours to fully cure before the transducers are mounted.

Posted in: Installation Questions